No exact matches found for wagner wagner power roller max electric paint roller 0514009 0514009
100 similar items found
Line Conditioner - Limited Warranty: 3 Year Limited - Width: 17" - Height: 4.1" - Depth: 12.8" - Input Voltage: 120 V AC - Receptacles: 11 - Frequency: 60 Hz
General Purpose Battery - Width: 1.9" - Height: 2.1" - Battery Chemistry: Sealed Lead Acid - Battery Rechargeable: Battery Rechargeable - Battery Capacity: 1300 mAh - Battery Size: Proprietary Battery Size - Output Voltage: 12 V DC
Battery Unit - Limited Warranty: 1 Year - Output Voltage: 12 V DC - Battery Type: Sealed Lead Acid
Line Conditioner - Limited Warranty: 3 Year Limited - Width: 17" - Height: 4.1" - Depth: 12.8" - Input Voltage: 120 V AC - Load Capacity: 1.50 kVA - Receptacles: 11
Woofer - RMS Output Power: 300 W - Maximum Frequency Response: 220 Hz - Minimum Frequency Response: 20 Hz - Impedance: 4 Ohm - PMPO Output Power: 1300 W - Driver Type: 12" Polypropylene Woofer - Sensitivity: 95 dB
Car Amplifier - Limited Warranty: 1 Year - Width: 9.7" - Height: 2.6" - Depth: 8.4" - RMS Output Power: 300 W - Impedance: 2 Ohm to 4 Ohm - PMPO Output Power: 640 W
$50+ Orders Ship Free
Shaft Power Monitor, M20, Height 90mm, Width 45mm, Depth 115mm, Voltage 380-500V, Relay Output 5 A/240 VAC Resistive, Hz 50/60, Analog Output Max Load 500 ohm, Input Current 100A, Protection Class IP20, Standards CE, UL, cUL
1/2 HP; MAX 2.4 Output amps @ 230 Volt. Operates standard 208/230V 3-phase AC motors, with 230V input single phase Power. Start provides more than 200% starting torque. Speed potentionmeter (pot) provided. Jumper selections: Forward-stop-reverse/Enable-automatic-manual. Not Recommended for use on air compressors. Speed potentiometer must be connected or the motor will not spin, without the pot the speed is set at zero and you will burn the motor up. "KBVF" Frequency Drive. A Low Cost, full featured, Motor Control / Frequency Drive. with 100% power output. Single phase input - Three phase output. If you have been to a used equipment auction and purchased a mill, lathe, drill press or other piece machinery with a three phase motor and are looking for a low cost solution to power it with single phase power. This may be your low cost solution. Unlike some of the electronic phase inverters that only output 2/3 of the power, this unit puts out 100% 3 phase power with 200% starting torque. You will need to eliminate any other motor switches. You will connect the motor directly to the 3 terminals on the converter. Otherwise the contacts from the old motor starter will allow feedback to the control that will damage the unit. The KB control becomes the motor starter. The unit should be powered through an electric power disconnect. When selecting drive size the motor amps cannot exceed the rated output amps of the control. Standard Features: Operates standard 208/230 VAC 3-phase AC motors, with 230 VAC input single phase. Power Start provides more than 200% starting torque. 30:1 speed range with full motor torque (Speed potentionmeter (pot) provided). (Motor should be inverter rated if using speed control feature). Controls 50hz and 60hz motors with a convenient jumper selection. Sinewave coded PWM-provides high motor torque and efficient operation. 16 khz switching frequency-provides quite motor operations. Motor overload protection. Jumper selections: Forward-stop-reverse/Enable-automatic-manual. You can use a 3-position toggle switch. Start 0-60,0-120, 0-50hz.Trimpot adjustments: Minimum Speed-min, Maximum Speed-Max. Important Application Information: Most fan-cooled (TEFC) 3-phase motors will overheat. if used with an inverter beyond a limited speed range at full rated torque. Therefore, it is necessary to reduce motor load as speed is decreased.Attention: Your motor amps cannot exceed the rated output amps of the converter. Note: Motor can not be run through contacts. Motor to be wired directly to controller. You will need to soldier leads to the potentiometer and connect it to the control.
FREE SHIPPING Orders $50+
Utilizing Bosch expertise in household appliances and automotive solutions, the Power Max 240 Volt charging station is UL-certified and is designed to safely charge electric vehicles.
Action Labs Yohimbe Power Max 2000 is one of the most potent sources of Yohimbe Bark Extract available today. Maximum potency. Fast-acting liquid.
Convection Heater - Limited Warranty: 5 Year - Width: 10" - Height: 13.5" - Depth: 11.5" - Color: Almond - Input Voltage: 240 V AC - Power Source: Electric
External Battery Pack - Width: 7" - Height: 6.8" - Depth: 6" - Output Voltage: 12 V DC - Battery Type: User Replaceable Sealed Lead Acid
Electric Monitoring Device - Limited Warranty: 6 Month - Width: 2.5" - Height: 5.1" - Battery Built-in: Battery Built-in
The NTPS-24-1.3 is a DIN rail mount power supply designed to be used with N-Tron's Industrial Ethernet products: INPUT SPECIFICATIONS: AC Voltage: 100-240VAC; Frequency: 47 to 63Hz; Input Current: <0.6A @ AC 100Vin, <0.35A @ AC 196Vin; Inrush Current: 36A max. @240VAC; DC Voltage: 85-375VDC
Battery Unit - Width: 1.9" - Height: 4.2" - Depth: 2.8" - Output Voltage: 6 V DC - Battery Type: Spill-proof, Maintenance-free Sealed Lead Acid
Convection Heater - Limited Warranty: 1 Year - Width: 11.4" - Height: 14.6" - Depth: 10.6" - Color: White - Material: Metal Leg - Power Source: Electric
Car Amplifier - Limited Warranty: 1 Year - Width: 9.7" - Height: 2.6" - Depth: 8.4" - RMS Output Power: 500 W - Impedance: 2 Ohm - PMPO Output Power: 770 W
Surge Suppressor/Protector - Limited Warranty: 3 Year - Width: 4.5" - Height: 4.5" - Depth: 2" - Input Voltage: 120 V AC - Output Voltage: 120 V AC - Receptacles: 2 x NEMA 5-15R
Speaker - RMS Output Power: 50 W - Maximum Frequency Response: 20 kHz - Minimum Frequency Response: 120 Hz - Impedance: 4 Ohm - PMPO Output Power: 100 W - Crossover Type: 2-way - Sensitivity: 90 dB
Speaker - RMS Output Power: 100 W - Maximum Frequency Response: 20 kHz - Minimum Frequency Response: 45 Hz - Impedance: 4 Ohm - PMPO Output Power: 200 W - Crossover Type: 3-way - Sensitivity: 93 dB